Velodyne CHT-Q Series Manual de usuario descargar pdf (Pagina 13)

www.velodyne.com

CHT-Q Series User’s Manual - 7

(2) SPEAKER LEVEL OUTPUT Terminals

Sends a crossed-over speaker-level signal to the front speakers. See below for a more detailed

explanationofthiscrossover.

(3) IR INPUT

Thisisaconnectionthatallowstheutilizationofathirdpartyinfraredremotesensor,suchasElanor

Xantech,oranextendedcableforplacementclosertoyourotherremotecontrolledequipment.This

keeps you from awkward control angles using the infrared remote control.

(4) LINE OUTPUT

Connect these jacks to the LINE IN preamp input to use the DEQ-R’s internal high pass crossover. The

signalfedfromtheseconnectorsisrolledobelow120Hz.

LINE INPUT/LFE

Connect these jacks to the LINE OUT preamp output, LFE output, or subwoofer output jacks of your

receiver/processor.IfusingtheLFEoutputfromyourreceiverorprocessor,plugthesinglecableinto

the“L”–LFEinputor,formoresignal,usea“Y”connector(notincluded)andfeedthesignalintoboth

“R” and “L” inputs.

(5) AUTO ON/OFF Switch

Usethisswitchtoselectbetween“stand-by”mode(woofershutsoaftereightminutes)and“always

on” operation.

(6) VOLUME Control

This control allows you to balance the output from the subwoofer to the main speakers in your system.

This control should be set to achieve similar volume level from between both the main speakers

and subwoofer. When pressing volume up or down, set the level while watching the LED display for

reference.

Note: Volume is also controllable by using the supplied remote. When defaults are restored,

the default is 30 out of 80.

(7) LOW-PASS CROSSOVER

Usethisknobtoselectthefrequencyabovewhichyouwishtocutothesignaltothesubwoofer.

When the knob is turned all the way to the left, the Subwoofer Direct feature is invoked and the

subwooferplaysallfrequenciesupto120Hz.

Rear Panel Connections — Detailed Explanation

Yournewsubwooferisequippedwithbothspeaker-levelandline-levelinputs.UsetheRCA/Phonotype“INPUT”

jackswhenconnectingyoursubwoofertoapre-amp,signalprocessor,orline-levelcrossover.The“SPEAKER

LEVELINPUT”jacksconnectdirectlytothespeakeroutputsofanintegratedamplierorreceiver.Youramplier

sectionwillnoticenoadditionalloadingeectswhenyouusetheseinputsbecauseoftheirhighimpedance.

Note:

DonotuseboththeRCA/Phono“INPUT”connectionsand“SPEAKERLEVELINPUT”connectionssimultaneously.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sin comentarios

Velodyne CHT-Q Series Manual de usuario Pagina 13