Velodyne MiniVee Series Manual de usuario descargar pdf (Pagina 10)

www.velodyne.com

4 - MiniVee User’s Manual

Auto Turn on Function

With this function in the “auto” position, your subwoofer can be safely left with the main power switched on

continuously. The subwoofer will turn itself on automatically when an audio signal is present. If no signal is

present for approximately 10 minutes, the unit will switch to standby mode. While in standby mode, your

subwoofer will draw very minimal power. This function can be disabled by leaving the switch in the “on” position.

Power Switch

Themasterpowerswitchislocatedonthelowerhalfoftheunit.Thisrockerstyleswitchisthemainon/ofor

theunit.Thisswitchshouldbesettoposition1(up)foron,and0(down)foro.Iftheunitistobeleftunused

foranextendedperiodoftime,themasterpowerswitchshouldbeturnedo.

Subwoofer Outputs

The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the built-

incrossover.Someprocessors/receivershavea“subwooferout”jackthatisinternallylteredanddesignedto

beusedwithaconventionalamplierandspeaker.Insomerarecases,combiningbothanexternalcrossover

and the one internal to the subwoofer may result in low output and increased noise. In these installations you

may need to bypass the internal crossover in either the processor or Velodyne subwoofer. In some installations,

simplysettingonecrossovertoahigherfrequency(suchas120Hz)willrestoremaximumperformance.To

bypass the subwoofer’s internal crossover when the unit is being fed a low pass signal from another crossover,

simply locate the switch marked INTERNAL X-OVER/SUBWOOFER DIRECT on the rear panel of the subwoofer

and set to the SUBWOOFER DIRECT position. This will eliminate the internal crossover from the signal path.

Note:Ifnotusinganexternalcrossover,youshouldusethebuilt-incrossoverforoptimalperformance.

LINE-LEVEL CONNECTION - OPTION A

Figure1showsconnectionfromyourhometheaterreceivertotheLFEinputonthebackofyoursubwoofer.

Whenthesubwooferisinstalledinthisfashion,allofthelowfrequencyinformationfromyour“LFEOut”or

“Subwoofer Out” on the back of your receiver will pass into your Velodyne subwoofer. This connection is the

mostcommonconnectionmethodwhenusingyoursubwooferwitha5.1receiver.(Cableneeded:1monoRCA

cable.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Velodyne MiniVee Series Manual de usuario Pagina 10