Velodyne SMS-1 Manual de usuario descargar pdf (Pagina 37)

www.velodyne.com

Digital Drive SMS-1 User’s Manual - 31

You can change any value in the presets column, then use the TEST key to review the curve with these settings

active. This is shown below.

Features of each preset are:

EQ. There can be a completely dierent set of EQs for each preset. Simply select the preset you want on

the “SYSTEM RESPONSE” screen where indicated.

Volume. This setting deviates the preset’s volume from the established system volume of the SMS-1. So, if

you found during setup that 30 was a good setup volume for the SMS-1, then if you increased the volume

for preset one to 40, the 40 volume would be invoked when preset one were selected for listening. If the

system volume is changed (using the VOL + or VOL – keys on the remote), the preset volume is adjusted in

lock step with the system volume.

Crossover, subsonic lter, phase and polarity settings. Normally these will not change from preset to

preset. However, it may be that you are using dierent satellites for dierent listening modes and wish to

set these settings individually for a specic preset. Note that the “setup” values cascade to the individual

values for the presets, but you can change all the individual values if desired.

Contour frequency and level. These act as an “extra” EQ that can be used to manipulate the frequency

contour of your SMS-1 when this particular preset is invoked. For example, notice that preset one raises

the level by 3 dB at 35Hz – this is to accommodate action/adventure movie content.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 48 49

Sin comentarios

Velodyne SMS-1 Manual de usuario Pagina 37