Velodyne SC-IWBB Manual de usuario descargar pdf (Pagina 15)

www.velodyne.com

SC-IW Installation Manual - 9

Step 8 - Place Clamp Rings on Driver Module

Remove the two clamp rings from the packaging and place a clamp ring onto each of the bottom edges of the

tubes.

Note: The position of the clamp ring is critical. Make sure that the screw section of the ring is on either side of

the tube and not on the front or the back. Please see picture below.

Figure 6: Clamp Ring Placement

Screw must

face outward

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Sin comentarios

Velodyne SC-IWBB Manual de usuario Pagina 15