Velodyne SC-IWBB Manual de usuario descargar pdf (Pagina 16)

www.velodyne.com

10 -SC-IW Installation Manual

Step 9 - Install Driver Module

Insert the driver module assembly through the opening left in the wall by the mudring and slide the plastic tubes

onto the two connection tubes The connection tubes should slide all the way down onto the surface of the

driver module assembly. Once the tubes are ush with the driver module, rmly tighten the two clamp rings to

seal the rubber coupling to the plastic tube.

Note: The silicon rubber tubes should slide over the tubes protruding from the driver module and the clamp

rings should slide over the silicon rubber tubes.

Figure 7: Driver Module Installation

Note: It is critical that a good air seal be achieved between the back box and the driver module. Be sure to

properly tighten all clamps. Test the seal by listening to the connection with test audio material after the install

is complete.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Sin comentarios

Velodyne SC-IWBB Manual de usuario Pagina 16