Velodyne SC-IWBB Manual de usuario descargar pdf (Pagina 21)

www.velodyne.com

SC-IW Installation Manual - 15

NEW CONSTRUCTION INSTALLATION —

DESIGNER GRILLE

Note: This installation process assumes that the installer has access to the open framed 2x4 studded wall with

16 inch spacing. (In the event that the stud spacing is larger, an additional 2x4 or other spacer can be used to

ll the space between the SC-IW back box and the neighboring stud.)

Step 1 - Assemble Cabinet and Driver Modules Together

Remove both the back box and driver modules from the packaging and place them on a clean surface. Place

the back box with the two silicon rubber tubes facing upward. Remove the two clamp rings from the packaging

and place them over the tubes.

Figures 13a and 13b: Cabinet and Driver Module Assembly

Note: Leave the paint cover on the driver to prevent damage during the installation, painting and nishing

process.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

Sin comentarios

Velodyne SC-IWBB Manual de usuario Pagina 21